Festool Kapex KS 120 User Manual download pdf (Page 15)

Using the MiterFast Tool

The MiterFast™ angle transfer tool converts a corner angle

measurement into a miter setting. The miter line in the

center of the tool is always at the midpoint of the two

angle arms, and when lined up with the saw’s laser,

provides the proper miter angle for the measured corner.

Supplemental User’s Manual 15

Measure the Corner

► For measuring an outside corner, extend the extension

arms as shown in the image below.

► For measuring an inside corner, retract the extension

arms as shown in the second image below.

1. Loosen the lock knob on the MiterFast tool.

2. Place the MiterFast tool in (or on) the corner and slide

the lock knob forward to expand the arms.

3. When the arms are lined up with the corner walls,

retighten the lock knob.

4. Place the MiterFast tool on the saw with one of the

arms up against the fence.

5. Turn on the laser for the saw. (Refer to Using the Laser

Guides

on page 11.)

6. Adjust the miter angle of the saw (refer to Setting the

Miter Angle

on page 12) until either of the laser beams

line up with the miter line on the MiterFast tool.

7. Lock the miter setting on the saw.

8. Fold up the MiterFast tool and return it to its storage

position in the base of the saw.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 31 32

No comments

Festool Kapex KS 120 User Manual Page 15