Festool MFT/3 User Manual download pdf (Page 8)

8

Step 6: Calibrating angle

Check the angle setting of the pre-set pro-

ﬁ le setting rail before starting work. Align

the guide rail ﬁ rst of all [Fig. 8].

Align the guide rail at right angles to the

pre-set proﬁ le setting rail. If an angle of

90° is not possible, slide a support unit on

the guide rail until the angle is correct. Se-

cure the guide rail.

NOTE: Slide the relevant stop [4-3] along

the table proﬁ le to retain the setting per-

manently.

If required, the pre-set proﬁ le setting rail

can also be aligned in relation to the per-

forated top provided the necessary clamps

(accessories) are available.

Insert the clamps [9-1] and [9-2] as shown

in Fig. [9] and move the stop ruler [9-3] to

a 90° position.

If the stop ruler does not rest evenly

against the clamps:

Loosen the screws [9-4] and the rotary

knob [7-2]. The retaining pin must be en-

gaged in the 90° notch.

Set the angle at 90° in relation to the

clamps and tighten the screws.

Step 7: Adjusting the pre-set

proﬁ le setting rail

Risk of injury! Always use

the fence in a ﬁ xed position and do not use

to slide the workpiece along!

Risk of injury! Make sure

that all rotary knobs on the fence are tight-

ened before starting work.

The fence can be adjusted in the following

ways:

9-2

9-1

9-3

9-4

9

8

90°

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 31 32

Comments to this Manuals

No comments