Festool CTL MIDI User Manual download pdf (Page 12)

CTL MINI/MIDI

"MAN" switch position

Appliance socket

[1-2]

is connected to the power, the

mobile dust extractor starts.

"Auto" switch position

Appliance socket

[1-2]

is connected to the power, the

mobile dust extractor starts when the connected tool

is switched on.



Insert the plug into an earthed socket.

Pull the plug from the socket when the ma-

chine is not in use and prior to maintenance

and cleaning work.

6.2 Connecting electric power tools



Connect the electric power tool to the appliance

socket

[1-2]

6.3 Connecting the suction hose [1A]



Connect the suction hose to the angle adapter

[1-

on the extraction opening

[1-5]

7Settings

7.1 Adjusting the suction power



Use the rotary knob

[1-1]

7.2 Applying the brake [1B]



Raise the front of the dust extractor slightly.



Push down the brake

[1-13]

until it engages into

position.



Actuate the lever

[1-12]

to release.

7.3 Temperature cut-out

A temperature cut-out switches the mobile dust ex-

tractor off when it reaches a critical temperature to

prevent overheating.



Switch off the mobile dust extractor, allow to cool

for about 5 minutes then switch on again.



Not possible to switch on: contact Festool service

workshop.

7.4 SYSDOC

A Systainer can be secured to the storage area

[1-7]

using the T-LOC latch

[1-8]

. Systainers without a T-

LOC can be secured using four SysDoc latches

[1-3]

8Working

8.1 Extracting dry materials

When extracting dust that exceeds the per-

mitted limit values, only extract from a single

machine (electric or air tool).

Observe

the following when extracting dust gener-

ated by operating electric power tools:

Ensure there is adequate ventilation! Observe re-

gional regulations!

Limit values:

exhaust air max. 50% of the clear air

volume

Formula:

room volume V

x air renewal rate L

8.2 Extracting wet materials/liquids

Remove the filter bag!

Recommendation:

use a special wet filter.

The dust extractor stops automatically when the

maximum level is reached.

After wet extraction, allow the main filter to dry!

8.3 After finishing work



Switch off the mobile dust extractor and pull out

the mains plug.



Wind up the mains power cable.



Empty the dirt trap.



Place the suction hose

[2-1]

and mains power ca-

ble

[2-2]

in the top section. Insert the mains cable

through the recess

[2-3]



Vacuum and wipe off the inside and outside of the

mobile dust extractor.



Place the mobile dust extractor in a dry room in-

accessible to unauthorised users.

WARNING

Risk of injury



Observe the maximum appliance socket con-

nected load (see chapter "Technical data")



Switch off the electric power tool.

CAUTION

Hazardous dust

Damage to the respiratory passage



Always use a filter bag!

CAUTION

Escaping foam and fluids



Switch off and empty the machine immediately.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 67 68

Comments to this Manuals

No comments

Festool CTL MIDI User Manual Page 12

Comments to this Manuals

Related products and manuals for Power tools Festool CTL MIDI